Petsafe Passport MPA19-13800 Guide D'installation page 3

• Do not install in a location where the Passport
compartment, and the power adaptor are exposed to damp or wet conditions or to water or outside
elements, such as rain or snow.
• If homeowner's door or other application is not level, the pet door must be installed level to
swing properly.
• When applying the cutting template, there should be a minimum of 3" (8 cm) between the bottom
and sides of the door and the outer edge of the template to maintain the structural integrity of
the door.
• Make sure there is nothing on the other side of the door where you will be drilling holes or cutting out
the opening.
• Use a manual screwdriver to tighten screws. Do not over-tighten. Over-tightening can strip the screws
or warp the pet door frame.
interior frame, including the LCD screen and battery
™
www.petsafe.net 3