Petsafe Passport MPA19-13800 Guide D'installation page 11

4G.
Move to exterior side. Align the three holes on the cutting template
with the three holes you just drilled. Tape template to exterior wall. Check to
ensure template is square. Realign if necessary. Using a pencil carefully trace
template. Remove template.
4H.
Drill ⁄ " (13 mm) holes in inside corners and top angle of drawn
1
2
template on exterior wall.
Helpful Tip: Use both hands to hold drill steady and straight at a 90
degree angle.
4I.
Starting in one of the holes you just drilled, carefully cut along drawn
template line using a jigsaw or other appropriate cutting device.
Helpful Tips: When cutting use both hands to hold the saw slow,
steady and straight at a 90 degree angle to the wall. If you are cutting
through vinyl siding, carefully score and cut the siding before cutting
through plywood.
Place assembled tunnel frames into cut-out with exterior
Fit
frame facing outside. The width of cut-out should be wider
Check
than tunnel frame to allow room for installation hardware
which will be installed in a later step. The height should allow tunnel
frame to move freely with no tight areas. If cut-out is too small, remove
tunnel frame and recut slightly to enlarge for tunnel to fit freely.
www.petsafe.net
4G
4H
(13 mm)
4I
11