Installation; Determine Pet Door Location; Prepare Door - Petsafe HPA11-10876 Guide D'installation

Installation

Step 1

Determine Pet Door Location

1A
1B
Step 2

Prepare Door

2A
2B
2C
1A. Measure and mark your pet's shoulder height on the interior side
of door.
1B. Determine location for the pet door. Draw a vertical center line
through the shoulder height line using a level.
2A. Remove door by removing door hinge pins.
2B. Place on a raised level surface such as saw horses. Place interior
side of door facing up.
Helpful Tip: Clamp down the door to prevent it from moving.
NOTE: The Pet Door can be installed with the door hanging
based on your skill level.
2C. Cut out template for Non-Glass Doors. Match the marked lines
on the door with the shoulder and center lines on the template.
Tape template in place and trace template. Make sure to trace
underneath tape and connect the corners. Remove the template
and any excess tape from the door.
www.petsafe.net
If homeowner's door or other application is
not level, the pet door must be marked level to
swing properly.
When applying cutting template there should be
a minimum of 3" between the bottom and sides
of the door and the outer edge of the cutting
template to maintain the structural integrity of
the door.
5