Installing And Connecting; First Use - Dovre Vintage 50 Installation Et Mode D'emploi

3. Install the connection collar on the bottom plate
and close the rear wall with the cover.
The guard is no 3 on the diagram.
Connection to outside air via the
rear of the appliance:
1. Make an opening in the wall (see Appendix 2,
Measurements, for the correct position of the
opening).
2. Hermetically close the air connection tube at the
wall.
3. Install the connection collar on the back wall and
close the opening in the bottom plate with the
cover.
The guard is no 4 on the diagram.
10

Installing and connecting

1. Install the appliance in the right place, and make
sure it is level.
2. Connect the appliance hermetically to the flue.
3. In the case of connection to outside air: connect
the outside air supply to the connector you have
fitted to the appliance.
4. Install all the parts you removed in the right places
in the appliance.
Never use the appliance without the fire-
resistant inner sheets.
The appliance is now ready for use.
Use

First use

When you use the appliance for the first time, make
an intense fire and keep it going for a good few hours.
This will cure the heat-resistant paint finish. This may
result in some smoke and odours. You could open
windows and doors for a while in the area where the
appliance is located.
Subject to change because of technical improvements