Checking The Seal - Dovre Vintage 50 Installation Et Mode D'emploi

Removing the glass pane
1. Loosen the 2xM5 nuts on the top only.
2. Tilt the pane forwards and lift the pane out of the
bottom fixing lips.
Before replacing:
1. Place the glass pane together with the two glass
fixings.
2. Tighten the 2xM5 nuts.
16
Touching up the finish
Small areas of damaged paint finish can be touched
up with a spraying can of special heat-resistant paint
finish available from your supplier.
Areas of damaged enamel can be touched up with a
special heat-resistant paint finish that is available
from your supplier.

Checking the seal

Check whether the sealing rope of the door is still
in good condition and works well. The sealing rope
is subject to wear and needs to be replaced in time.
Check the appliance for air leaks. Close any
chinks with stove sealant.
Let the sealant harden fully before you start a
fire in the appliance, because otherwise any
moisture in the sealant will form bubbles in the
sealant and cause a new air leak.
Subject to change because of technical improvements