Dovre Vintage 50 Installation Et Mode D'emploi page 35

Note the location of those removable parts, so
that you have no difficulties in installing the
parts in the right place later on.
1. Open the door; see the following figure.
2. Remove the fire-resistant inner plates; see the
following figure.
The following tips may help in the removal of the
inner plates:
a. Lift baffle plate 3 on the front and pull it
forwards by 2 cm.
Subject to change because of technical improvements
b. Now, lift the baffle plate on the left-hand side
and remove the left-hand inner plate 1 first.
c. Then remove baffle plate 3 followed by inner
plates 7, 8, 9, 2 etc.
Cast iron inner plates protect the
combustion chamber and dissipate heat to
the environment.
Removable internal sections
1 left-hand side inner plate
2 right-hand side inner plate
3 baffle plate
centre bottom of the fire
4
compartment
5 bottom fire basket
6 top fire basket
7 left-hand rear inner plate
8 centre rear inner plate
9 right-hand rear inner plate not for Vintage 30
left-hand bottom of the fire
10
compartment
rear bottom of the fire
11
compartment
right-hand bottom of the
12
fire compartment
13 ash removal port
3. Remove the ashtray.
Please note: the Vintage 30 does not have an
ashtray.
4. Install the adjustable feet under the legs, see
figure. When used on a slippery floor surface, it is
not for Vintage 30
not for Vintage 30
not for Vintage 30
not for Vintage 30
not for Vintage 30
not for Vintage 30
not for Vintage 30
7