Resetting The Safety Thermal Cutout; Normal Maintenance; Technical Data; Dimensions Diagram - Stiebel Eltron DHC-E 8 Utilisation Et Installation

INSTALLATION

NORMAL MAINTENANCE

If you are not able to resolve a problem please contact us,
(see rear cover), before removing the appliance from the
wall. STIEBEL ELTRON is happy to provide technical assis-
tance. In most instances, we can resolve the problem over
the phone.

10.3 Resetting the safety thermal cutout

DANGER: Electrocution
Do not attempt to reset the safety thermal cutout of
this water heater unless power to the unit has been
completely shut off at the circuit breakers.
Safety
thermal
cutout
The safety thermal cutout on the DHC-E is designed to cut off
electrical power to the heating elements if water of too high a
temperature is encountered. When the safety cutout has tripped,
it must be reset manually.
To reset the safety cutout, use the following procedure:
Turn off the circuit breaker attached to the water heater
Remove the front cover of the water heater
Identify the safety thermal cutout on the top of the copper
heating canister. The button at the top is the reset button.
Press down on the button, take note of whether it clicks or
not when pressed.
11. Normal maintenance
STIEBEL ELTRON tankless water heaters are designed for a very
long service life. Actual life expectancy will vary with water qual-
ity and use.
To ensure consistent water flow, it is recommended to
periodically remove scale and dirt that may build up at the aera-
tor of the faucet(s), the filter screen in the appliance, or in the
shower head.
8 | DHC-E

12. Technical Data

12.1 Dimensions diagram

b01
c06 c06 c01 c01
4˝(10 cm)
7¾˝(20 cm)
b01 Electrical cable entry
c01 cold water inlet
c06 hot water outlet
1½˝(3.8 cm)
4¼˝(11 cm)
½˝ NPT
½˝ NPT
www.stiebel-eltron-usa.com