Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Preparing for installation
9.
Preparing for installation
Note
Connect the hydraulic connections with flat gaskets.
9.1
Fitting the thermal insulation, if appropriate
f Position the appliance in its intended site.
f
f Fit the thermal insulation according to the instructions sup-
f
plied. For this, ensure that there is enough space for the
installation task. You can then link the appliance into the
heating system.
14
13
1 Cover
2 Top thermal insulation section
3 Top thermal insulation section
4 Top thermal insulation ring
5 Convection brake (only WDH cool)
6 R.h. thermal insulation section
7 Cover strip
8 Connection cover (including insulation)
9 Thermal insulation, flange
10 Flange cover
11 Thermal insulation section, bottom
12 Thermal insulation ring, bottom
13 Rose
14 Left thermal insulation section
www.stiebel-eltron.com
1
2
3
4
5
6
7
8
9
10
11
12
f On cylinders supplied horizontally, insert the bottom thermal
f
insulation section inside the support ring, prior to position-
ing the cylinder. Slightly tip the vertically delivered cylinder
in order to position the bottom thermal insulation section.
f Surround the support ring with the bottom thermal insula-
f
tion ring and secure it with adhesive tape.
f Remove the foil from the 5 foam strips (convection brakes)
f
and stick them around the cylinder in the positions shown.
f Prior to fitting them, shape the right hand and left hand ther-
f
mal insulation sections into a semi-circular form for approx.
10 seconds. A pressure-activated adhesive then holds the
thermal insulation sections in the required shape and makes
fitting them easier.
Please note that the use of tensioning straps may damage the
thermal insulation.
f Push the thermal insulation sections over the connections on
f
the appliance.
f Connect the thermal insulation sections at the front by clip-
f
ping the hook closure strip into the last hook strip. If neces-
sary, the short black cover strips can be used to temporarily
hold the hook closure strips together.
f Position the thermal insulation sections around the cylinder
f
and connect the thermal insulation sections at the back by
clipping the hook closure strip into the first or second hook
strip.
f Adjust the thermal insulation sections on the appliance by
f
patting and pressing them down with the palm of the hand.
f Starting from the top, retighten the hook closure strip from
f
the top until it hooks into the final hook strip.
f Place the thermal insulation ring and the two thermal insula-
f
tion sections on the top.
f Place the cover over the thermal insulation sections.
f
f Fit the cover strips onto the hook closure strips. If required,
f
the cover strips can be trimmed to size.
f Fill the hollow spaces near the connections with the soft
f
foam inserts.
f Push the roses and caps into the apertures.
f
Note
Affix the additional type plate in a clearly visible position
on the thermal insulation.
9.2
Installing the manual air vent valve
f Install a manual air vent valve at the air vent valve
f
connection.
SBP 1000-1500 E | E SOL | E cool |
17
Publicité
Chapitres
Table des Matières
Dépannage
