Starting A Programme - Zanussi ZDSN653X2 Notice D'utilisation

• If the rinse aid indicator is on, fill the rinse
aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start a programme suitable for the type
of load and the degree of soil.
USING THE DETERGENT
A B
CAUTION! Only use detergent
specifically designed for dishwashers.
1. Press the release button (B) to open the lid (C).
2. Put the detergent, in powder or tablets, in the
compartment (A).
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the release button
locks into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a
load with normal soil.
Do not fill the compartment (A) with
more than 30 ml of gel detergent.
SETTING AND STARTING A PROGRAMME
The Auto Off function
This function decreases energy consumption by
deactivating automatically the appliance when it is
not operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was not started.
30
20
C

Starting a programme

1. Press the on/off button to activate the
appliance. Make sure that the appliance is in
programme selection mode.
2. Close the appliance door.
3. Press repeatedly until the indicator of the
desired programme is on.
The display shows the programme duration.
4. Set applicable options if desired.
5. Press to start the programme.
• The indicator of the running phase is on.
• The programme duration counts down in
minutes.
Starting a programme with delay start
1. Set a programme.
2. Press repeatedly until the display shows
the desired delay time (from 1 to 24 hours).
3. Press to begin the countdown.
• The indicator
• The remaining time counts down in hours.
The final hour is displayed in minutes.
When the countdown is complete, the programme
starts and the indicator of the running phase is on.
The indicator is off.
Opening the door while the appliance
operates
Opening the door while a programme is running
stops the appliance. It may affect the energy
consumption and the programme duration. After
closing the door, the appliance continues from the
point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
Do not try to close the appliance door
within 2 minutes after AirDry
automatically opens it as this may
cause damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running
programme ends.
Cancelling the delay start while the
countdown operates
When you cancel the delay start, you have to set a
programme and options again.
is on.
13