Glasscare - Zanussi ZDSN653X2 Notice D'utilisation

OPTIONS
Desired options must be activated
every time before you start a
programme.
It is not possible to activate or
deactivate options while a programme
is running.
The Option button toggles between
the available options and their possible
combinations.
Not all options are compatible with
each other. If you select non
compatible options, the appliance
automatically deactivates one or more
of them. Only the indicators of the still
active options are on.
If an option is not applicable to a
programme, the related indicator is off
or it flashes quickly for a few seconds
and then goes out.
Activating options can affect the water
and energy consumption as well as
the programme duration.
SETTINGS
PROGRAMME SELECTION MODE AND
USER MODE
When the appliance is in programme selection
mode it is possible to set a programme and to enter
user mode.
Settings available in the user mode:
• The level of water softener according to the
water hardness.
• Activation or deactivation of the rinse aid empty
notification.
• Activation or deactivation of the AirDry.
As the appliance stores the saved settings,
there is no need to configure it before every
cycle.
How to set the programme selection mode
The appliance is in programme selection mode
when the programme indicator
the display shows the programme duration.
After activation, the appliance is in programme
selection mode by default. If not, set the
programme selection mode the following way:

GLASSCARE

This option provides special care for a delicate
load. It prevents rapid changes in the wash
temperature of the selected programme and
reduces it to 45 °C. This protects glassware from
damaging.
How to activate GlassCare
Press
The display shows the updated programme
duration.
EXTRAPOWER
This option improves the washing results of the
selected programme. It increases the wash
temperature and duration.
How to activate ExtraPower
Press
The display shows the updated programme
duration.
Press and hold simultaneously
appliance is in programme selection mode.
How to enter user mode
Make sure the appliance is in programme selection
mode.
To enter user mode, press and hold simultaneously
and
flash and the display is blank.
THE WATER SOFTENER
The water softener removes minerals from the water
supply, which would have a negative effect on the
washing results and on the appliance.
The higher the content of these minerals, the harder
your water is. Water hardness is measured in
equivalent scales.
is on and
The water softener should be adjusted according to
the hardness of the water in your area. Your local
water authority can advise you on the hardness of
the water in your area. It is important to set the right
until the indicator is on.
until the indicator
until the indicators
is on.
and until the
, and
9