Before First Use - Zanussi ZDSN653X2 Notice D'utilisation

• The display shows the current setting.
– = the rinse aid empty notification
is deactivated.
– = the rinse aid empty notification
is activated.
2. Press to change the setting.
3. Press the on/off button to confirm the setting.
AIRDRY
AirDry improves the drying results with less energy
consumption. The appliance door opens
automatically during the drying phase and remains
ajar.
AirDry is automatically activated with all
programmes other than
The duration of the drying phase and the door
opening time vary depending on the selected
programme and options.

BEFORE FIRST USE

1. Make sure that the current level of the
water softener agrees with the hardness
of the water supply. If not, adjust the level
of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any processing
residuals that can still be inside the appliance.
Do not use detergent and do not put dishes in
the baskets.
After starting the programme, the appliance
recharges the resin in the water softener for up to 5
minutes. The washing phase starts only after this
procedure is complete. The procedure is repeated
periodically.
(if applicable).
When AirDry opens the door, the display shows the
remaining time of the running programme.
CAUTION! Do not try to close the
appliance door within 2 minutes after
automatic opening. This can cause
damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running
programme ends.
CAUTION! If children have access to
the appliance, we advise to deactivate
AirDry. The automatic opening of the
door may pose a danger.
How to deactivate AirDry
Make sure the appliance is in user mode.
1. Press .
• The indicator
• The remaining indicators are off.
• The display shows the current setting:
– = AirDry is deactivated.
– = AirDry is activated.
2. Press to change the setting.
3. Press the on/off button to confirm the setting.
THE SALT CONTAINER
CAUTION! Use rough salt designed
for dishwashers only. Fine salt
increases the risk of corrosion.
The salt is used to recharge the resin in the water
softener and to assure good washing results in
daily use.
How to fill the salt container
1. Turn the cap of the salt container
counterclockwise and remove it.
2. Put 1 litre of water in the salt container (only for
the first time).
3. Fill the salt container with 1 kg of salt (until it is
full).
still flashes.
11