Zanussi ZDSN653X2 Notice D'utilisation page 19

Problem and alarm code
The appliance trips the circuit-
beaker.
Refer to "Before first use", "Daily
use", or "Hints and tips" for other
possible causes.
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
For alarm codes not described in the table, contact
an Authorised Service Centre.
THE DISHWASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or blu-
ish layers on glasses and dishes.
There are stains and dry water
drops on glasses and dishes.
The interior of the appliance is
wet.
Possible cause and solution
• The amperage is insufficient to supply simultaneously all the ap-
pliances in use. Check the socket amperage and the capacity
of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised
Service Centre.
Possible cause and solution
• Refer to "Daily use", "Hints and tips" and the basket load-
ing leaflet.
• Use more intensive washing programme.
• Activate the ExtraPower option to improve the washing re-
sults of a selected programme.
• Clean spray arm jets and filter. Refer to "Care and Clean-
ing".
• Tableware was left for too long inside the closed appliance.
Activate the function AirDry to set the automatic opening of
the door and to improve the drying performance.
• There is no rinse aid or the dosage of rinse aid is not suffi-
cient. Fill the rinse aid dispenser or set the dosage of rinse
aid to a higher level.
• The quality of the rinse aid can be the cause.
• Always use rinse aid, even with multi-tablets.
• Plastic items may need to be towel dried.
• The programme does not have the drying phase. Refer to
"Programmes overview".
• The released quantity of rinse aid is too high. Adjust the rinse
aid dosage to a lower level.
• The quantity of detergent is too high.
• The released quantity of rinse aid is not sufficient. Adjust the
rinse aid dosage to a higher level.
• The quality of the rinse aid can be the cause.
• This is not a defect of the appliance. Humidity condensates
on the appliance walls.
WARNING! We do not recommend
using the appliance until the problem
has been completely fixed. Unplug the
appliance and do not plug it in again
until you are certain that it operates
correctly.
19