Zanussi ZDSN653X2 Notice D'utilisation page 18

Problem and alarm code
The programme does not start.
The appliance does not fill with
water.
The display shows i10 or i11.
The appliance does not drain
the water.
The display shows i20.
The anti-flood device is on.
The display shows i30.
The appliance stops and starts
more times during operation.
The programme lasts too long.
The displayed programme du-
ration is different than the du-
ration in the consumption val-
ues table.
The remaining time in the dis-
play increases and skips nearly
to the end of programme time.
Small leak from the appliance
door.
The appliance door is difficult
to close.
The appliance door opens dur-
ing the wash cycle.
Rattling/knocking sounds from
inside the appliance.
18
Possible cause and solution
• Make sure that the appliance door is closed.
• Press Start.
• If the delay start is set, cancel the setting or wait for the end of
the countdown.
• The appliance recharges the resin inside the water softener.
The duration of the procedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in the user
manual.
• It is normal. It provides optimal cleaning results and energy sav-
ings.
• If the delayed start option is set, cancel the delay setting or wait
for the end of the countdown.
• Refer to the consumption values table in the chapter "Pro-
grammes".
• This is not a defect. The appliance is working correctly.
• The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
• The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
• The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The AirDry function is activated. You can deactivate the func-
tion. Refer to "Settings".
• The tableware is not properly arranged in the baskets. Refer to
basket loading leaflet.
• Make sure that the spray arms can rotate freely.