Stihl MS 251 Notice D'emploi page 39

All versions with two pawls
1
2
3
Use a screwdriver or suitable pliers
N
to remove the spring clip (1) from
the starter post.
Carefully remove the rope rotor with
N
washer (2) and pawls (3).
WARNING
The rewind spring may pop out and
uncoil during this operation – take care
to avoid the risk of injury.
Replacing a Broken Starter Rope
Standard versions
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new rope through the
N
starter grip and tie one of the knots
shown.
Pull the knot back into the grip.
N
MS 251, MS 251 C
Models with ElastoStart
3
Pry the cap out of the starter grip.
N
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new rope through the
N
starter grip and tie a simple
overhand knot.
Pull the knot back into the grip.
N
Refit the cap in the grip.
N
Versions with Easy2Start
Remove the remaining rope from
N
the rotor and starter grip.
Thread the new rope through the
N
starter grip and tie one of the knots
shown.
English
37