Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Notes:
#
Do not change the entry under "Username".
#
The camera password cannot be changed under "Password". To change the
camera password, proceed as described in Chapter 12.2.3.
12.5 Delete camera access on the mobile device [42 -Delete]
!
To delete camera access on your mobile device, press the recycle icon [43]
and confirm with "YES".
Note:
Access to the camera will only be deleted on this particular mobile device. If
other mobile devices have access to the camera, access to the camera can be set
up on additional mobile devices as described under 9.2. However, if access to
the camera has been deleted on all mobile devices, access to the camera must
be set up as described under 9.1. if required.
13. Installation
!
Before fixing the camera permanently, test the quality of the connection
and optimise the camera view.
The camera can be wall or ceiling mounted (see fig. B: I and II).
!
First disconnect the camera from the power supply.
!
To install the camera on a wall or ceiling, affix the camera in a suitable spot
using the supplied screws [15] and, where applicable, wall plugs [14].
When mounted on the ceiling the camera's tilt angle may need to be
flipped and the image rotated by 180° (see Chapter 10.1.1 "Flip").
!
Align the camera.
!
Rotate the antenna [1] so that it points upwards..
!
Connect the mains adapter with a suitable mains outlet. The POWER LED
[2] lights red.
14. Reset / loss of camera password
!
To reset the settings and the camera password to the factory settings,
proceed as described in Chapter 12.2.8 "Reset Factory Settings".
!
Alternatively, you can press the reset button [12] on the camera, e.g. with
a straightened paper clip, until the connection LED [6] goes out. Then wait
approximately 30 seconds until it starts to blink. Then proceed as described
in Chapter 9.1 from "Connect camera to mobile device".

15. Maintenance and cleaning

#
The product is maintenance-free: do not open the housing
#
Check the safety and function regularly
#
Remove the mains adapter from the mains socket before cleaning
#
Use a soft, slightly moist cloth or brush to clean the surfaces
16. Disposal
Packaging material or electrical products must not be disposed of as
household waste. Use your recycling system. Details are available
from your local authority.
17. Declaration of conformity
Indexa GmbH , Paul-Böhringer-Str. 3, D- 74229 Oedheim declares that this
product AC20 complies with the basic requirements and the other relevant
regulations of Directive 1999/5/EC. Conformity has been demonstrated. The
complete declaration of conformity can be read at: www.indexa.de.
This product can be used in the following countries:
D
A
L
CH
18. Legal Notices
This product or software may contain or make use of code under the GNU
General Public License v2 e.g. the linux kernel, the GNU Lesser General Public
License v2.1 or the Apache licence v2.0.
For further information regarding license terms and – where required by license
– source codes please send an email to copyrequest@indexa.de to get them
free of charge. Some licenses, however, require the provision of physical copies
of the source code. In this case, you may obtain a copy of the source codes by
contacting us as well via copyrequest@indexa.de. A nominal fee (i.e., the cost
of physically performing the source distribution) will be charged for this service.
Note:
your copy of this product may not contain code covered by one or more of
the licenses listed here, depending on the exact product and version you choose.
The corresponding license texts can be found at the end of the manual.
19. Warranty
In addition to the statutory guarantee from the vendor, the manufacturer
warrants this product for 2 years from date of purchase (proof from receipt)
according to following conditions.This warranty does not affect your legal
rights. The warranty covers use of the product in normal conditions in private
households. It only covers manufacturing defects and is limited to the
replacement or repair of the faulty components. It does not include wear and
tear, or batteries. The warranty applies only when the product is used
according to the operating instructions. It does not cover damage arising from
misuse, improper handling, application of force, dust, dirt, water or other
environmental factors, or from incorrect voltage from batteries or power
supply. The warranty is void when the product has been repaired or tampered
by unauthorised persons and when it has been used with components which
are not specified by the manufacturer. In case of a warranty claim please
contact the vendor for details of how to proceed and how to return the product
if necessary. Only carriage paid authorised returns will be accepted. Repairs
can only be accepted when accompanied by a full description of the fault.
After the warranty period has expired repairs will be charged and are not
always possible. Warranty claims do not extend the warranty period and the
warranty for replacement parts expires with the warranty for the product.
Unless there is a statutory obligation, the manufacturer is not responsible for
further claims, including peronal or material damages, arising from the use of
the product or from nonfunction or misfunction of the product.
Indexa GmbH, Paul-Böhringer-Str. 3, 74229 Oedheim, Germany
NL
B
IRL
GB
www.indexa.de
GB - 39

Publicité

Table des Matières
loading

Table des Matières