Renkforce 1359882 Notice D'emploi page 98

Resetting the outputs #1 or #2 with the superuser code
While the code lock is in regular operation (not in programming mode), you can reset output #1
or #2 with the superuser code (see chapter 11. e).
Example: The superuser code was programmed to be "6789":
1. Example: Setting output #1 to toggle mode
(a) (b) (c)
(a) Start programming for activation duration of output #1
(b) Code "0" for toggle mode
(c) Save programming (code lock emits two beeps)
2. Example: Activation duration for output #2
(a) (b) (c)
(a) Start programming for activation duration of output #2
(b) Set duration (timer) to 3 seconds
(c) Save programming (code lock emits two beeps)
98
Resetting output #1/ending timer
Resetting output #2/ending timer