Renkforce 1359882 Notice D'emploi page 86

Proceed as follows to save a user code or a transponder:
• The code lock must be in programming mode; see chapter 11. b).
• Enter the programming code for output #1 or #2:
• Select the desired function:
• Enter the memory slot number.
.....
.....
• Depending on the chosen function, you now either need to hold the transponder against the
sensor surface of the code lock, or enter the user code or the separate secondary code.
• Confirm your input with the
• The code lock emits two beeps; programming is saved.
• You can now set up another user (start with input of the number
for output #2 again).
• When you have completed programming of all users, leave programming mode; see chapter
12. b).
86
Output #1
Output #2
Access only via transponder
Access only via user code
Access via transponder + separate secondary code
Access via transponder + shared secondary code
Deleting user code or transponder
Deletes all user codes/transponders for the selected output (#1 or #2) (this
may take up to one minute, depending on how many data are pre-set)
1000 memory slots for output #1
100 memory slots for output #2
button.
for output #1 or