Renkforce 1359882 Notice D'emploi page 108

If the door opener button is released too early in function
of the delay will be reset and output #1 will not be activated.
For reasons of safety, the corresponding notice sign therefore must be attached next
to the door opener button to explain the function (e.g. if a delay of 5 seconds has been
programmed: "Keep the door opener button pushed for at least 5 seconds until the
door opener is triggered!").
• Select the delay:
.....
• Confirm your input with the
• The code lock emits two beeps; programming is saved.
1. Example: Delay 5 seconds, warning sound is activated, door opener button only needs
to be pushed briefly
(a) (b) (c)
(a) Start programming of delay
(b) Function "2": The warning sound is activated, the door opener button only needs to be pushed
briefly to activate output #1 (or a connected door opener).
(c) Set delay to 5 seconds
(d) Save programming (code lock emits two beeps)
108
No delay (default setting); output #1 is activated immediately after the door
opener button is pushed
Delay in seconds (can be set from 1....99 seconds); output #1 is only activated
after the end of the set time
button.
(d)
or , the internal timer