Checking The Machine; Check The Direction Of Blade Rotation (Three-Phase Current Only); Operation; Prior To Initial Operation - Hofmann A2204 Instructions D'utilisation

• Plug the mains plug into the socket provided.

3.4. Checking the machine

• Please check the safety equipment in keeping
EN
with chapter 1.9.
• Please check whether the machine is operational
when switched on. Does the machine itself or the
support start creeping ? In the affirmative, ensure
a more solid support (see chapter 3.2).
3.5. Check the direction of blade rotation
(three-phase current only)
Warning!
Rotating blade! May sever fingers. Do not
reach into the running blade !
• Press the On button. The machine starts up.
• • Check the direction of blade rotation. The blade
must turn from the top downwards against the
product.
4.

Operation

4.1. Prior to initial operation

• Please check the safety equipment (chapter 1.9).
• Thoroughly clean the machine (chapter 6).

4.2. Cutting operation

Warning!
Rotating blade! May sever fingers. Do not
reach into the running blade !
• Pull the carriage all the way back.
• Lift the last slice device
• Place the product at the rear carriage wall
• Place the last slice device from the top on to the
product
• Press the green on button. The machine will start
operating.
• Lift the last slice device
• Push the carriage forward and backward for cut-
ting.
18

4.3. Cutting end pieces

Press the green on button. The machine will start
operating.
Push the carriage forward and backward for cutting.
Press the product with the end
piece holder against the top plate.

4.4. Switching the machine off

• Press the red off button.
• Turn the adjusting knob for the cutting thickness
clockwise to top, beyond - 0 - to cover the blade
edge.
5.

Cleaning

The machine has to be cleaned thoroughly at least
once a day.
Warning !
Rotating blade ! May sever fingers. Switch
the machine off prior to cleaning. Remove the
mains plug. Always wear protective gloves
with writ protection for cleaning the blade.
Important !
Please observe the sequence given for cleaning.
Do not use any scouring agents to clean the
machine, as they scratch the metal surface and
thus have a negative effect on hygiene.
Only use commercially available detergents
and hygiene agents. Neutralise aggressive de-
tergents and hygiene agents after cleaning.
Never use a steam or high pressure cleaner to
clean the machine ! In case of non-observation
of the above points our warranty will become
ineffective.

5.1. Preparation

• Press the red off button.
• Remove the mains plug from the socket.
• Turn the adjusting knob for the cutting thickness
clockwise up to the stop, beyond - 0 -, so that the
face of the knife is covered.

5.2. Tilting the carriage

Pull the carriage right up to the front beyond the
pressure point of the spring.
Tilt the carriage to the side.
Important !
The carriage can be tilted down only, if the ad-
justing knob for the cutting thickness is turned
clockwise to stop.