Installing The Intenza+ Water Filter; Replacing The Intenza+ Water Filter - Gaggia Milano CADORNA MILK Mode D'emploi

English
16
Filter expired, replace
or disable it
clean/setting
ON/OFF my favourites HOME
WATER FILTER
REPLACE
ACTIVATE
DISABLE
ON/OFF my favourites HOME
4219-450-08051 MANUAL GAG. CAD. MILK EN-FR 120US.indd 16

Installing the INTENZA+ water filter

Remove the small white filter from the water tank and store it in a dry place.
Immerse the INTENZA+ water filter vertically (with the opening pointing up) in cold
water and gently press its sides to let any air bubbles out.
Remove the INTENZA+ water filter from the water. Set the machine according to
the detected water hardness (see the "Measuring water hardness" chapter) and the
letters found on the filter base:
A = soft water – 1 or 2 small squares
B = hard water (standard) – 3 small squares
C = very hard water – 4 small squares
Place the INTENZA+ filter in the water tank, ensuring it is correctly in place. Refill
the water tank and place it in its compartment.
Follow the instructions shown on the display to activate the filter.
Note: you can pause the filter activation procedure by pressing the START/STOP
button. To resume the procedure, press the START/STOP
START/STOP

Replacing the INTENZA+ water filter

When the INTENZA+ water filter runs out, the display will show an alarm message.
1 Replace or deactivate by pressing the CLEAN/SETTING
the " SETTINGS " button.
2 Select the " WATER FILTER " button.
START/STOP
3 Select " REPLACE " to change the filter or " DISABLE " if you do not intend to
use the filter. Confirm with the "
Follow the instructions shown on the display to activate the filter correctly.
clean/setting START/STOP
START/STOP
clean/setting
" button.
button again.
button, and then
23/04/2020 09:57:35