Parkside PATC 2 A1 Instructions D'utilisation Et Consignes De Sécurité page 9

Before use
Charging the product
Note: Remove all packaging materials from the product.
Note: You can recharge the product using a normal household socket
or using your car's cigarette lighter socket.
Note: The fuse of the car adapter
nical data of the fuse must comply with information given in the sec-
tion "Technical data". The fuse may only be replaced by a qualified
electrician.
CAUTION! Do not connect the product to your car's cigarette
lighter socket if the car battery is already old and worn. Doing so
could mean that the car engine will no longer start.
Note: In order to use the product without a mains adapter
car adaptor , you need to recharge the rechargeable battery
12
before use. The charging process takes about 5–7 hours.
Note: Charge the product for approx. 12 hours prior to first use.
Connect the USB cable
adapter
11
Connect the micro-USB connector on the USB cable
micro-USB input socket
Plug the mains adapter
into the cigarette lighter socket in your vehicle.
12
Note: During charging from a cigarette lighter socket, ensure that
the car adapter
lighter socket of the vehicle. Failure to observe this advice may result
in risk of fire from overheating
Note: During charging, the charging indicator
When charging is complete, the charging indicator
green. When the charging indicator
adapter out of the socket or the car adapter
11
cigarette lighter socket. Disconnect the adapter from the product to
prevent the rechargeable battery from discharging.
Use
You can secure the product by using the folding hook
magnetic base
Using the product without
a power connection
Fully charge the product as described in the section
"Charging the product".
Press the ON / OFF switch
spotlight
1
Press the ON / OFF switch
spotlight
1
Press the ON / OFF switch
light and switch on the orientation light
1
Press the ON / OFF switch
light .
6
To switch on the telescopic work light
carefully out of the lamp body, with holding the grip
1
To switch the telescopic work light
light
back into the lamp body, with holding the grip
1
Fig. A).
The lamp head may be titled over 90º to allow for lighting a
specific work area (see Fig. A).
with the USB connector of the mains
13
or the car adapter
on the product.
8
into a socket, or plug the car adapter
11
is always completely inserted into the cigarette
12
on a flat, ferromagnetic surface.
4
2
with full power.
2
with low power.
2
2
can be exchanged. The tech-
12
.
12
9
is green, pull the mains
9
12
once to switch on the hand
again to switch on the hand
again to switch off the hand spot-
.
6
again to switch off the orientation
, pull the hand spotlight
3
off, push the hand spot-
3
or a
11
to the
13
lights up red.
lights up
9
out of the
or the
10
.
7
(see
7
GB/IE/NI 9