Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4
In the State of Massachusetts, the following installation instructions apply:
Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
Acceptable Shut-off Devices: Gas Cocks and Ball Valves installed for use shall be listed.
A flexible gas connector, when used,must not exceed 4 feet (121.9 cm).
Anti-Tip
Bracket
Range Foot
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Tape measure
■
Phillips screwdriver
■
Torx
T20
screwdriver
®†
®†
■
Flat-blade screwdriver
■
1/8" (3.2 mm) flat-blade
■
screwdriver
Level
■
Hand or electric drill
■
Wrench or pliers
■
Pipe wrench
■
15/16" (23.8 mm)
■
combination wrench
Parts supplied
Check that all parts are included.
Propane/Natural Gas Conversion Kit (located on back of
■
range near lower side)
Burner grates
■
Burner caps
■
Oven racks
■
2 - #12 x 1
⁄
" (4.1 cm) screws (for mounting anti-tip bracket)
5
■
8
†
TORX and T20 are registered trademarks of Acument Intellectual Properties, LLC.
®
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation instructions.
Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed and engaged.
Failure to follow these instructions can result in death or serious burns to children and adults.
To verify the anti-tip bracket is installed and engaged:
• Slide range forward.
• Look for the anti-tip bracket securely attached to floor or wall.
• Slide range back so rear range foot is under anti-tip bracket.
• See installation instructions for details.
INSTALLATION REQUIREMENTS
1/8" (3.2 mm) drill bit
■
Marker or pencil
■
Pipe-joint compound
■
resistant to propane gas
Noncorrosive leak-
■
detection solution
For Propane/Natural Gas
Conversions
1/2" (12.7 mm)
■
combination wrench
9/32" (7.0 mm) nut driver
■
Masking tape
■
WARNING
Tip Over Hazard
Anti-tip bracket (taped inside upper oven with package
■
containing literature)
Anti-tip bracket must be securely mounted to the back wall
or floor. Thickness of flooring may require longer screws to
anchor bracket to subfloor. Longer screws are available from
your local hardware store.
Parts needed
Check local codes and consult gas supplier. Check existing gas
supply and electrical supply. See the "Electrical Requirements"
and the "Gas Supply Requirements" sections.
Location Requirements
IMPORTANT: Observe all governing codes and ordinances. Do
not obstruct flow of combustion and ventilation air.
It is the installer's responsibility to comply with installation
■
clearances specified on the rating number plate. The rating
number plate is located behind the control panel.
The range should be located for convenient use in the
■
kitchen.
Recessed installations must provide complete enclosure of
■
the sides and rear of the range.
All openings in the wall or floor where range is to be installed
■
must be sealed.
3
Publicité
Table des Matières
