Installation Requirements; Tools And Parts - KitchenAid 30" (76.2 CM) Instructions D'installation

In the State of Massachusetts, the following installation instructions apply:
■ Installations and repairs must be performed by a qualified or licensed contractor, plumber, or gasfitter qualified or licensed by
the State of Massachusetts.
■ If using a ball valve, it shall be a T-handle type.
■ A flexible gas connector, when used, must not exceed 3 feet.
Anti-Tip
Bracket
Range Foot
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
■
Tape measure
■ #2 Phillips screwdriver
¹⁄₈" x 4¼" flat-blade
■
screwdriver
■
Level
■ Drill
■ Wrench or pliers
■ Pipe wrench
■
Adjustable wrench or
⁵⁄₈" wrench
³⁄₈" drive ratchet
■
¹⁄₈" drill bit
■
¹⁵⁄₁₆" combination wrench
■
4
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation instructions.
Slide range back so rear range foot is engaged in the slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed and engaged.
Failure to follow these instructions can result in death or serious burns to children and adults.
To verify the anti-tip bracket is installed and engaged:
• Slide range forward.
• Look for the anti-tip bracket securely attached to floor or wall.
• Slide range back so rear range foot is under anti-tip bracket.
• See installation instructions for details.

INSTALLATION REQUIREMENTS

Tools and Parts

¹⁄₄", ³⁄₈", ⁵⁄₁₆" nut drivers
■
³⁄₁₆" carbide tip masonry bit
■
■ Marker or pencil
■ Pipe-joint compound
resistant to LP gas
■ Noncorrosive leak-detection
solution
■
Tubing cutter
For LP/Natural Gas
Conversions
■ Adjustable wrench
■
½" deep-well socket
■ 7 mm nut driver
■ Masking tape
WARNING
Tip Over Hazard
Parts supplied
Check that all parts are included.
■ Anti-tip bracket kit
A
A. Anti-tip bracket
B. #8-18 x 1" Phillips head screws (4)
NOTE: Anti-tip bracket must be securely mounted to
subfloor. Thickness of flooring may require longer screws to
anchor bracket to subfloor. Longer screws are available from
your local hardware store. See "Install Anti-Tip Bracket"
section.
■ Gas pressure regulator
■ Burner grates
■ Burner bases and caps
■
Grill grate (on grill models)
■ Wave tray (on grill models)
■ Flame spreader (on grill models)
B