KERN and SOHN SFB 10K1HIP Mode D'emploi page 72

Remove the transportation lock:
1. Models platform size 300 x 240 mm
Remove the marked screws.
2. Models platform size 400 x 300 mm
Remove the screw marked by the label
Attention: The sealed screws must not be unscrewed.
Accurate weighing results require a weighing bridge with perfect horizontal
alignment. During initial installation and after each change of work area it is
necessary to level the weighing bridge.
16
.
 As the air bubble is located under
the weighing plate, remove it.
 Level balance with foot screws until
the air bubble of the water balance
is in the prescribed circle.
SFB-BA-e-1625