MAS-...
S
In order to fit the adapter as described in the section "Accessories," screw it
into the fastening thread 1.
The forces occuring during assembly can be reduced if the thread is slightly
greased. The appropriate tightening torque is specified in the table below.
MAS-...
Connect-
ing thread
Nm
Fig. 9
S
When placing the moveable mass, make
sure that the following points are ob-
served:
– the maximum permitted transverse
offset of the connections
– the maximum permitted angle offset
– the maximum permitted overhang
– the maximum permitted values for
forces and additional masses
The permitted values can be found in the
secton "Technical specifications" (and in
the diagrams in the chapter "Characteris-
tic curves").
S
Fasten the work load at the front plate so
that the mass centre of gravity of the work
load is aligned with the centre axis.
Pneumatic components
S
Wire up the compressed air connection on
the adapter (A) of the MAS-... .
Festo MAS-... 0010NH - English
10
20
40
M10 x
M16 x
M20 x
1,25
1,5
1,5
8 ... 13
15 ... 25
35 ... 45
Fig. 8
Fig. 10
Fig. 11
(A)
Fig. 12
1
19