FREE DOSE BEVERAGE DELIVERY
Do steps:
,
,
and
DELIVERY
PRESSO
.
Press the FREE DOSE BEVERAGE
ton to start delivery. Once the desired amount of
brewed coffee is reached, press the button again
to stop brewing.
For a new supply cycle, wait for supply buttons
and multifunction button turning on with steady
white light.
Once supply is over, lift and then lower the capsule
loading lever to unload the exhausted capsule.
In case of soluble pods, it is recommended that a
brief plain (i.e. by using only water) supply should
be dispensed before inserting the pod, so that you
can best enjoy the product.
COFFEE DOSE PROGRAMMING
Measures are always programmed using the same
key; any other keys are ignored. The programmed
amount of brewed coffee (minimum 20 ml / 0,6 oz)
can be changed by repeating the programming.
Should a coffee dose lower than 20 ml (0,6 oz) be
set, the coffee machine will store in any case the
minimum coffee dose that can be set.
PREPARING THE COFFEE
in paragraph ES-
but-
Lift the capsule loading lever until it locks into po-
sition to open the capsule fitting compartment.
Put a Lavazza
fitting compartment.
Lower the capsule loading lever to close the pod
fitting compartment.
Press and hold one of the two coffee delivery
for at least 5 seconds. The selected button will
flash and the coffee machine will enter the pro-
gramming mode. Now release the key.
Once the desired coffee amount is reached, stop
the brewing by pressing the button again.
If the programmed measure exceeds the maxi-
mum allowed (240 ml) the machine will automati-
cally stop delivery, the delivery button will blink
and the last programmed measure will be saved in
the memory.
If there is a power failure during programming, the
last programmed value remains in the memory.
If during a dose programming, water lack is indi-
cated, the machine stops the supply and the dose
being programmed won't be saved. Once filled
the water tank, repeat the dose programming pro-
cedure.
EN
capsule into the pod
/
29