Dose Programming - LAVAZZA LB COMPACT Mode D'emploi

E N
In case of the dosed espresso button,
the supply will stop automatically when the pre-
gramming" paragraph).
In case of the free supply button,
press the button again once the desired amount
of coffee is found in the cup, to stop the coffee
supply.
The button will light up and flash when the coffee
is supplied. After the coffee has been supplied,
the button will remain ON, i.e. it will fort flash and
then light up steadily, to indicate the machine
ready status. In case of quite long repeated supply
instances, the machine ready status might come
after a heating phase (in this case, both supply
buttons will flash).

DOSE PROGRAMMING

The upper button is for the espresso dose (facto-
ry-set amount: approximately 40 ml).
The lower button is for the free dose as factory-
set, i.e. able to be set by the user themselves. The
dose associated with this button can in any case
be programmed, too.
How to program the doses:
1
Lift the pod loading lever: the red light indica-
tor will flash alternating with the upper supply
button.
2
Insert the pod.
16
MAKING COFFEE
3
Close the lever.
4
for 5 seconds. The machine will enter the pro-
gramming mode.
-
mode, the LED for the selected button will alter-
5
Now, you can release the selection button and
wait for the desired dose to be obtained.
6
Press the flashing button to stop the supply and
store the dose into the memory.
REMOVING THE USED PODS
This operation must be carried out when the
machine is ON.
The lower supply button and the central LED will
flash alternately to indicate that the used pod
tray is full and needs be removed, emptied and
seconds, the machine will reset the count of the
pods found inside. Such reset will be indicated
by the central LED and the lower button lighting
up simultaneously for 2 seconds.
5 seconds