LAVAZZA INOVY COMPACT IF900 Mode D'emploi page 33

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Do not drink the descaling solution and prod-
ucts dispensed until the completion of the cy-
cle. Never use vinegar as a descaling solution.
Insert the water tank with the descaling solution.
The machine will start automatically the descaling
cycle.
During the descaling cycle, the water tank
warning light and the pod drawer
light flash alternately.
During the descaling cycle the machine per-
forms automatically pauses to allow emptying
of the container.
At the end of dispensing the decalcification solu-
tion, the cycle is temporarily suspended. Remove
the drop drawer and the exhausted pod drawer,
then empty the container used for the descaling
solution.
Capsule drawer warning
light flashing.
Fit the drawers inside the machine and position
the container under the spout.
Remove the water tank, rinse and wash it accurate-
ly. Fill it with fresh still mineral water.
Water tank warning light
ON with light flashing.
Insert the water tank. The machine will start auto-
matically the rinse cycle.
To finish the rinse cycle, it is necessary to dispense
a minimum amount of water, refill the tank if nec-
essary.
During the rinse cycle, the machine sets auto-
matically in pauses to allow emptying the con-
tainer.
At the end of the delivery, the rinse cycle is com-
pleted.
The flashing of the dispensing
nate with the button
indicates the presence
of the water filter in the tank. Insert the filter and
press a delivery key to confirm.
Remove the drop drawer and the exhausted pod
drawer, then empty the container used for rinsing.
MACHINE SETUP
warning
light ON with red
/
alter-
ENABLE/DISABLE TANK
FILTER PRESENCE
Press the MULTIFUNCTION button
switch to the LONG ESPRESSO button
which lights up
Press LONG ESPRESSO button
access the function and subse-quently enable or
disable the filter presence.
• FILTER ON:
• FILTER OFF:
= Off 
= On 
Press the MULTIFUNCTION button
the changes and exit the sub-menu.
SETTING THE TEMPERATURE
The MULTIFUNCTION button
steady, white light.
The capsule drawer lamp
eye light.
The ESPRESSO supply button
light.
Press twice the MULTIFUNCTION button
the machine menu.
The FREE DOSING supply button
white light.
Press the FREE DOSING button
temperature setting menu.
The machine as default value is set at low tem-
perature.
Press the FREE MEASURE DELIVERY button
to select the machine temperature.
Low:
Normal:
Hight:
= Off 
= On 
Press the MULTIFUNCTION button
temperature setting and exit the menu.
EN
to
,
again to
= Flashing
to save
slights up to a
lights up with red-
is lit with white
in
is lit with
to open the
= Flashing
to save
33

Publicité

Table des Matières
loading

Table des Matières