Midi Setup - Two notes Audio Engineering Torpedo C.A.B. Manuel De L'utilisateur

Parameter
A Sw
A Ho
B Sw
B Ho
MIDI CC
MIDI PC
MIDI CHANNEL
MIDI MONITOR
REMOTE MONITOR
Firmware
Serial

8 MIDI setup

The MIDI parameters can be found on the SETUP menu. The Torpedo C.A.B. handles both pre-
set change commands (PROGRAM CHANGE or PC) and parameter change commands (CONTROL
CHANGE or CC). This way, you can interact with all the parameters on the unit from any kind of
standard MIDI controller, like a MIDI pedalboard or a keyboard.
1. Select if the unit is to receive PROGRAM CHANGE and/or CONTROL CHANGE commands. For
example, if you plan to use the preset switching (PC), the CC receive can be Off.
2. Set the MIDI channel that your unit will listen to. You can choose to receive all channels, which
is useful when you don't know exactly on which channel the commands are sent.
3. With the MIDI monitor, check the correct reception of the commands by the Torpedo C.A.B..
Two notes Audio Engineering
CHAPTER 4. CONFIGURING AND USING THE TORPEDO C.A.B.
Value
Short click on A function
Hold A function
Short click on B function
Hold B function
Control Change receive, On or Off
Program Change receive, On or Off
MIDI Channel selection, from 1 to 16 or ALL (the machine listens to all
MIDI channels)
Incoming MIDI command monitoring
• "- -": a command is received on a MIDI channel other than the
one you selected for the machine.
• "In": a command is received on the channel you have selected
for the machine.
• No Connection: no active USB connection
• USB Connected: active USB connection
• Remote connected: active USB connection, sync with the Tor-
pedo remote
Current firmware version of the Torpedo C.A.B.
Serial number
Torpedo C.A.B. 29