Publicité
Fig 7. Remove the locking ring ... prying it up using a small screwdriver ...
REPL ACING THE GE AR AND COUPLING
A. Place the rubber coupling into the locking ring so the rubber feet from the coupling
hang below the ring. When placing the coupling and ring on the center shaft of the
fan, the rubber feet should line up with the notch marks on the fan. Snap the ring and
coupling into place.
B. With the gear laying on its side, place it between the motor housing arms that sus-
pend it above the fan.
C. While placing the palms of your hands against the motor assembly arms, apply
slight pressure, and pivot the gear to the upright position. Check that the locking knob
is properly seated in the support arm.
D. Insert the rubber coupling into the bottom of the gear and push it up into the gear
until it fits tight. On models with a small white pin, first insert the pin through the
rubber coupling and then push both up into the gear until it fits tight. Check that this
is properly seated by spinning the fan with your hand. The teeth in the gear should
slowly move in and out.
A.... Place the rubber coupling into the
locking ring ...
24
US
B.... place it between the motor
housing arms...
Publicité
