Publicité
4.4- Replacing the blade
Danger!
Immediately after cutting, the saw blade can be extremely hot – burning hazard! Let the hot
blade cool down.
Do not clean the saw blade with combustible liquids.
Injury hazard, even if the blade is stopped. Wear gloves when changing blades.
During assembly, observe the direction of rotation of the saw blade!
1. Loosen all coach screws, washers, locking nuts on right blade outer guard. And remove the right
outer blade guard.
REMARK
Unscrew the bolt, the washer and the locking
nut on the spring guide tube and place the
spring and the washer onto the spring guide
tube, push the supporting leg (A) towards the
blade and insert the spring guide tube into the
hole on supporting leg (B) and fasten it.
Place the switch on the motor plate with 4 bolts
M4X55.
Before using the machine, fix the 4 holes at the
bottom of the stand with 4 bolts M8x20.
Page 55 of 63
Publicité
