Publicité
4.3- Assembly
Assembly step 1
Assembly step 2
M8X40
M6X15
M8X15
Supporting legs
Bolt M8X40 2pcs
Washer Ø8 2pcs
Locking nut M8 2pcs
Supporting leg with working table (A) 1pc
Supporting leg with motor (B) 1pc
Connection of supporting leg with working
table (A) to supporting leg with motor (B) by
using 2 bolts M8x40, 2 washers 8mm and 2
locking nuts M8.
Leave the supporting leg (A) to lie on the
ground.
Assemble the rod by using 1 bolt M8X25 and 1
locking nut M8 but do not over tighten so that
the rod remains mobile.
Saw blade outer guard (part I)
Screw M6X15 1pc
Screw M8X40 1pc
Screw M8X15 1pc
Locking nut M6 1pc
Locking nut M8 2pcs
Saw blade outer guard F
Connection of saw blade outer guard to
supporting leg with motor (B) by using 1 screw
M6X15, 1 screw M8X40, 1 screw M8X15, 1
locking nut M6 et 2 locking nuts M8.
Page 50 of 63
Publicité
