Publicité
5. Set the flame length to 2 to 3 mm by
means of the screw (1) on the oven tap.
Turning in clockwise direction reduces
the flame, turning counter-clockwise in-
creases the flame.
If gas flow rate of oven cannot be
set with removing knob, please re-
move the needed oven parts (con-
trol panel, burner plate etc.) and
then set the gas flow rate of oven.
If the temperature of the oven in-
creases excessively, turn off the
oven and call the authorised ser-
vice to have oven thermostat re-
paired.
Set the flame to optimum length as shown
in figure below by means of the screw 1 on
the oven tap. Turning clockwise direction
reduces the flame, turning counter-clock-
wise increases the flame.
If the flame is too small,
* oven temperature can be too low, thus
cooking performance can be affected ad-
versely.
Ideal flame length provides the best per-
formance.
If the flame is too big,
* oven temperature can be too high, thus
cooking performance can be affected ad-
versely.
After making gas flame adjustment
open and close the door repeatedly
and make sure that oven flame
does not go out.
Leakage check at the injectors
Before carrying out the conversion on the
product, ensure all control knobs are turned
to off position. After the correct conversion
of injectors, for each injectors should be
gas leak checked.
1.
Make sure that the gas supply to the
product is on, still maintaining all con-
trol knobs turned to off position.
2.
Each injector hole is blocked with a fin-
ger applying reasonable force to stop
the gas leakage when corresponding
control knob turned to on and it held at
depressed position to allow gas reach
the injector.
EN / 32
EN
FR
Publicité
