Publicité
Flow rate adjustment screw
1
Exchange of injector for the oven
1. Turn all control knobs to off positions
on the control panel.
2. Shut off the gas supply.
3. Remove the screws shown below on the
rear wall.
4. Remove the rear wall.
5. Remove the 2 screws (2) located on the
injector holder (1).
1
Injector holder
2
Screw
6. Remove the injector holder.
7. Remove the injector in the injector
holder by turning it counterclockwise.
8. Install the new gas injector.
Reduced flow adjustment for the gas oven
For the appropriate functioning of the oven
re-checking the by-pass adjustment is ex-
tremely important. In order to provide max-
imum security to the user these operations
have to be done with care.
1. Ignite the burner that is to be adjusted
and turn the knob to the high flame posi-
tion.
2. Close the oven door and wait for 10 to
15 minutes until the oven becomes
ready for adjustment.
3. Take out the knob
4. After 15 minutes, adjust the oven to the
lowest flame position.
EN / 31
EN
FR
Publicité
