Publicité
Using a cooking appliance with
piped gas leads to heat and humid-
ity being produced in the area
where the appliance is installed.
Make sure there is good ventilation
in the space where the appliance is
installed. Keep all natural ventila-
tion apertures open, or install a
mechanical ventilation device such
as an extraction hood. Prolonged or
intensive use of the appliance may
call for additional ventilation such
as opening windows, or for more
effective ventilation by increasing
the power of the extraction hood if
any.
4.4 Placing the product
1. Push the product towards the kitchen
wall.
2. Secure the safety chain you have con-
nected to the product to the wall.
3. Adjust the feet of oven
Adjusting the feet of oven
Vibrations during use may cause cooking
vessels to move. This dangerous situation
can be avoided if the product is level and
balanced.
For your own safety please ensure the
product is level by adjusting the four feet at
the bottom by turning left or right and align
level with the work top.
Final check
1. Reconnect the product to the mains.
2. Check electrical functions.
3. Open gas supply.
4. Check whether the gas connections are
securely attached and whether there are
any leaks.
5. Ignite burners and check appearance of
the flame.
Flame must be blue and have a reg-
ular shape. If the flame is yellowish,
check if the burner cap is seated
securely or clean the burner.
4.5 Gas Conversion
General warnings
• Before starting any work on the gas in-
stallation, disconnect the gas main sup-
ply. There is the risk of explosion!
• All gas injectors must be replaced and
the burning adjustment of the gas taps
must be made in reduced flow rate posi-
tion in order to make the product suitable
for use with another gas.
• After the gas type has been changed, the
new gas type label on the spare bag must
be applied onto the current label already
on the backwall of product.
• The convertible gas type and gas cat-
egories of your product by country are
given in the "Country gas categories/
types/pressure" section. Check the table
in this table for the types of gas you can
convert in your local area. You cannot
convert to unspecified gas types in this
table.
• Spare injector suitable for the type of gas
you wish to convert may not be supplied
with product. You can obtain the inject-
ors from the authorized service or from
the place where you purchased the
product.
• Injector values and gas types that should
be used for burners are given at the end
of the section. Make the connection of
the gas type to be converted as de-
scribed in the gas connection section.
Parts for Gas Conversion
The parts and tools visuals, may be re-
quired for the gas conversion are given be-
low. Depending on the model, these parts
may not be given with the product.
Bypass nozzle:
EN / 29
EN
FR
Publicité
