Publicité
• Oxygen from the air fuels the gas com-
bustion. This means that the air must be
permanently refreshed and combustion
products evacuated (an air flow of 2m3/h
per kW of power is needed).
• This appliance is not connected to an ex-
traction device for combustion products.
It should be installed and connected in
conformity with the regulations in force;
special attention should be paid to ventil-
ation equipment.
• Gas hosing should not be in contact with
any fitted item moving parts (such as a
screw) and should not pass through
places where there is a risk the hosing
could be crushed.
• The legal texts concerned in France are
decrees dated 02/08/1977 and
24/03/1982, complemented by the
Standard. DTU-P 45204 (= DTU 61.1)
from the CSTB "Gas Installations",
Standard [Norme] NFC 15.100 (electrical
low voltage installation regulations).
• The heat produced by this appliance
classifies this cooker as type X under
electric Standard EN 60.335.2.6 (incor-
porated), as class 1 (non-incorporated)
or in class 2 sub-class 1 (incorporated)
under gas Standard EN 30.1.
Bendy piping or flexible hosing
should be accessible for servicing
over the whole length, and should
be replaced before the use expiry
date (indicated on the piping). Max-
imum length should be no more
than 1.25 metres.
Gas connection is made at the back
of the appliance, Make sure the pip-
ing does not come into contact
with other parts of the appliance,
and that it does not pass through a
space that is cluttered or in contact
with another moving part.
Gas connection
Your product comes with a kit gas connec-
tion, consisting of:
• 2 washers
• 1 adapter
• 1 Butane nozzle
• 1 Natural gas nozzle
According to the gas you use and the type
of pipe, observe the following configura-
tions. Interposer joints as shown on the
drawing.
A. For Butane / Propane gas connection
with a hose clamp and is on the tip Butane,
which is set on the adapter, which in turn
attaches to the stove (Figure A).
B. The connection "mechanical" is flexible
with the adapter, which is itself fixed on the
oven (Figure B).
The butane end piece allows connection
using flexible rubber hosing with 6 mm in-
ternal diameter suitable for bottle gas.
The end piece for piped gas allows con-
nection by bendy piping of 15 mm internal
diameter, such piping being strengthened
so that it can be mandatorily held in place
by a locking collar. Use piping carrying the
NF-GAZ stamp. This piping is regularly to
be replaced before its use expiry date.
Do not use a lighter or a match to
check for a gas leak.
Checking seal-tightness : Make
sure that all knobs on the stove are
in the off position and the gas
bottle connection is open. Use soap
to check for any gas leaks. Any leak
will cause the soap to bubble. If
this happens, check the gas con-
nection again.
EN / 28
EN
FR
Publicité
