Assembly - STOK SGA7040 Manuel D'utilisation

UNPACKING
This product requires assembly.
 Carefully remove the product from the box. Make sure
that all items listed in the packing list are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
 If any parts are damaged or missing, please call
1-800-847-5993 for assistance.
PACKING LIST
Cotter Pins (4)
Natural Gas Burners (4)
Natural Gas Data Label
Natural Gas Manifold and Valve Assembly
Screws (4)
10 ft. Natural Gas Hose w/quick-connect coupler
WARNING:
If any parts are damaged or missing, do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
CAUTION:
Some parts may contain sharp edges that may cause
personal injury. Wear protective gloves if necessary.

ASSEMBLY

STEP 1: TURN OFF THE GRILL
See Figure 3.
 Open the hood.
 Turn all control knobs on the control panel OFF ( O ).
Fig. 3
STEP 2: DISCONNECT PROPANE GAS
CYLINDER
See Figure 4.
 Open cabinet doors.
 Make sure handwheel on the propane gas cylinder is in
its full off position.
 Holding coupling nut and regulator as shown, turn coupling
nut counter-clockwise and disconnect by hand. Do not
use tools.
WARNING:
To avoid serious personal injury, always check for gas
leaks any time a gas cylinder is disconnected and then
reconnected.
COUPLING NUT
Fig. 4
6 - English
CONTROL
KNOBS
REGULATOR