Assembly - STOK QUATTRO SGP4330 Manuel D'utilisation

UNPAcKiNG
This product requires assembly.
 Carefully lift grill from the carton and place it on a level
work surface.
NOTE: This grill is heavy. To avoid back injury, keep
your knees bent and lift with your legs, not your back,
and get help when needed.
WARNiNG:
Do not use this product if any parts on the Loose
Parts List are already assembled to your product
when you unpack it. Parts on this list are not as-
sembled to the product by the manufacturer and
require customer installation. Use of a product that
may have been improperly assembled could result
in serious personal injury.
 Inspect the grill carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have
carefully inspected the grill, identified all loose parts,
and satisfactorily operated the grill.
NOTE: Some loose parts are located inside the grill as-
sembly beneath the hood.
 If any parts are damaged or missing, please call
1-800-847-5993 for assistance.
WARNiNG:
If any parts are damaged or missing, do not operate
this grill until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
cAUTiON:
Some parts may contain sharp edges that may
cause personal injury. Wear protective gloves if
necessary.

ASSEMBLY

STEP 1: iNSTALLiNG THE cASTER ASSEMBLy
See Figure 5.
The right side of the base has a circular cut-out where the
LP gas tank will be placed. The two locking caster assem-
blies should be installed on the right side of the base.
 Tilt the caster assembly so the hook on the underside
of the caster can be placed under the base.
 Keeping the hook under the base, tilt the back of the
caster assembly until the holes in the caster assembly
align with the holes in the base.
 Slide bolts (2), M6 x 15 mm (CC), through the tab on
the rear of the caster assembly and into the base.
 Using washers (BB), lock washers (DD), and hex nuts,
M6 (FF), tighten caster assembly securely to the base.
 Repeat for the other three caster assemblies.
 Set the base on a flat surface.
Fig. 5
STEP 2: ASSEMBLiNG SiDE PANELS TO THE
BASE
See Figure 6.
 Slide the tabs into the slots then sit the panel on the
base aligning the holes in the tabs at the bottom of the
right side panel with holes on the left side of the base.
 Slide bolts, M5 x 12 mm (EE) three per side, through
both the tab and into the base. Tighten securely.
 Repeat above steps to install the left side panel.
9
bolts
(cc)
hook
washer (bb)
lock washer (dd)
base
hex nut
(ff)
locking
caster
assembly