STOK SGA7040 Manuel D'utilisation page 8

STEP 7: REMOVE IGNITOR CAP AND NUT
See Figures 9 and 10.
 Turn the ignitor cap counterclockwise and lift cap from
the control panel.
 Remove AA battery (if installed).
 Turn nut counterclockwise and remove.
 Push ignitor through the control panel and allow it to hang.
NUT
Fig. 9
IGNITOR
Fig. 10
ASSEMBLY
STEP 8: REMOVE THE CONTROL PANEL
See Figures 11 and 12.
 Loosen and remove the six screws securing the control
panel.
 Carefully remove the control panel from the grill.
STEP 9: DISCONNECT THE ELECTRODE WIRES
FROM THE IGNITOR
See Figure 12.
 Locate the wires going from the ignitor to the electrodes
inside the firebox.
 Carefully disconnect the wires from the ignitor. Keep
IGNITOR CAP
ignitor for reassembly.
SCREWS
Fig. 11
Fig. 12
8 - English
CONTROL
PANEL
ELECTRODE
WIRE
IGNITOR