Télécharger Imprimer la page

GRAVOGRAPH M40 Serie Manuel Technique page 26

Publicité

Lift up a little bit the CPU board before to pull on it on right
side.
Soulever légèrement la carte UC avant de la tirer vers la
gauche.
Reassembling operation   ‐ Opération de remontage 
Put the CPU board front of the power board connector, and
then push it to connect it.
Mettre la carte UC face au connecteur de la carte PUI puis
pousser la afin de la connecter.
Put the 5 screw to fix the CPU board.
Remettre les 5 vis pour fixer la carte UC.
Put back the electronic rack inside the machine. see chapter M40- 005
o Remettre en place le boîtier électronique. voir chapitre M40-
005.
This operation is finished,
Origin adjustment spindle and red pointer see chapter M40-A01
Z auto adjustment M40-A02
Opération terminée,
o
Réglage point zéro broche et pointeur rouge voir chapitre M40-A01.
Réglage Z-AUTO – M40-A02
NOTICE TECHNIQUE GAMME M40 
M40 RANGE TECHNICAL MANUAL 
You must process to the following adjustments:
vous devez maintenant effectuer les réglages suivants :
Page - 27
Date : June 2009   From 
Aftersales Technical Support 
Ref. M40 GB/FF     ‐     Vers. 1.0

Publicité

loading

Produits Connexes pour GRAVOGRAPH M40 Serie