Publicité
Transport
1. Turn the steering wheel to full left lock (19).
2. Loosen the cap screw (20) on the channel
holder by 5 - 6 turns.
3. Lower the mower mechanism to the lowest
position "1" and lock (21), see chapter 6.6.1
"Adjusting the cutting height (06, 08)",
page 34.
4. Unhook the tension spring from the mower
mechanism (22).
5. Move the mower mechanism back up to the
top (23).
6. Disconnect the V-belt duct (24).
7. Unhook the V-belt from the V-belt sheave of
the engine (25).
8. Lower the mower mechanism to the lowest
position "1" again and lock (26), see chapter
6.6.1 "Adjusting the cutting height (06, 08)",
page 34.
9. Remove the 4 locking pins (27) from the
mower mechanism mounting brackets.
10. Pull off the holding clips over the pins (27).
11. Move the height adjustment lever to the high-
est position "7=T" (= Transport position) and
lock (28), see chapter 6.6.1 "Adjusting the
cutting height (06, 08)", page 34.
8.6
Renewing the V-belt
To change the v-belt, please contact an autho-
rised dealer.
9 TRANSPORT
When the lawn tractor is transported using trans-
port equipment (e.g. trailers towed by cars), the
mower mechanism must be supported from be-
Malfunction
Engine does not start. Lack of fuel.
494296_a
Cause
Poor quality, contaminated fuel,
old fuel in tank.
Air filter contaminated.
No ignition spark.
low in order to reduce the strain on the mower
mechanism mounting.
During transport, make sure that the means of
transport has a sufficient load capacity and that
the lawn tractor is suitably secured.
10 STORAGE
The lawn tractor should be parked where it is pro-
tected against the effects of weather, especially
moisture, rain and lengthy exposure to direct sun-
light.
Never store the lawn tractor inside a building
when its fuel tank contains fuel, if there is poten-
tial for fuel vapours to come into contact with na-
ked flames or sparks. Only park the lawn tractor
in rooms that are suitable for the storage of motor
vehicles.
When storing the lawn tractor for long periods,
such as over winter, it should not have its fuel
tank filled if possible. The fuel can evaporate.
Before long-term storage, the fuel should be
drained from the tank and the carburettor in order
to avoid any build-up of deposits, which could re-
sult in problems when starting. Please contact
your specialist workshop for advice.
11 HELP IN CASE OF MALFUNCTION
CAUTION! Risk of injury. Sharp-edged
and moving appliance parts can lead to injury.
■
Always wear protective gloves during mainte-
nance, care and cleaning work!
NOTE For malfunctions that are not listed in
this table or that you cannot resolve yourself,
please contact our customer service.
Remedy
Fill tank; check tank bleeding; check fuel
filter.
Always use fresh fuel from clean con-
tainers; clean carburettor (customer ser-
vice workshop).
Clean air filter (see operating instruc-
tions from engine manufacturer).
Clean the spark plug, replace with a
new one if necessary, check ignition ca-
ble, check ignition system (customer
service workshop).
39
Publicité
