Publicité
(2) According to different wired remote controller installation methods, choose one of the following
two ways to install the mounting plate and connect the cable.
Method 1: To mount the wired remote controller directly on the surface of a wall:
A. Secure the mounting
plate onto the wall
with M4×16mm
screws (supplied)
Method 2: to install the wired remote controller on a surface mounting box:
a. Prepare the optional field-supplied surface mounting box which can fit the mounting plate.
b. Feed the cable through the conduit in the wall.
Mounting Plate
c. Insert the harness plug into the connector.
NOTES:
Pay attention to the path of the connection wiring between the wired remote controller
•
and the indoor or outdoor unit. Run the wiring away from power supply cables and keep a
minimum distance of 0.3m with any other electronic or electric device, to avoid any potential
jamming electric noise.
In case the controller is installed near other electric or electronic devices, use the shielded
•
cable(SPX-WKT5MS, 5m) to connect the wired remote controller to the indoor or outdoor unit.
(3) Re-attach the wired remote controller body to the controller
mounting plate. Be careful not to pinch the cable when attaching
it.
(4) After installation, remove the protective film from the LCD screen.
A16382H32B
Cable
Cable Tie
(Field-Supplied)
Surface Mounting Box
M4 Screws
(Field-Supplied)
2. Installation Work
Draw-out Hole
D. Attach the cable tie to
the cable at the inside
of the draw-out hole.
B. Insert the harness plug
into the connector
30
7
23
3-7
Insert the harness plug
Remove the
protective film.
Unit: mm
111
30
23
2-4.3
23
5
Publicité
