Publicité
2. Installation Work
2. Installation Work
[Before Installation]
(1) This packing contains the following parts.
Name
Appearance
Qty.
*: Standard connection cable delivered with the controller: 5m(unshielded);
Optional cable with 5m length(shielded): SPX-WKT5MS;
Optional cable with 15m length(unshielded): SPX-WKT15M.
(2) When installing two wired remote controllers one above
the other, allow a gap of at least 2 inches(50mm) between
the two.
[Installation Procedures]
(1)
Insert the edge of the slotted screwdriver into the groove at the bottom of the holding bracket,
push and turn the slotted screwdriver to separate and remove the wired remote controller from
the mounting plate.
Groove Part
NOTE:
Do not insert the slotted screwdriver into the tab beside the groove. The tab may be damaged and
•
the advanced color wired remote controller cannot be installed.
4
Installation & Operation
SPX-URFG1
1
Tabs for Attaching Controller
Manual
1
Slotted
Screwdriver
Figure Seen from Bottom Side
Mounting Plate
Cable
Screw
M4 × 16mm
5m*
1
2
more than 2 inches(50mm)
Approx. 1/4 inches(6mm)
A16382H32B
Publicité
