Publicité
9. Service Settings
9.3.5 E4: Fan Speed at Heating Thermo-OFF
Step1.
Select "E4: Fan Speed at Heating Thermo-OFF" on
"3d: Cycle Operation" screen and press "OK".
Step2.
Press " " or " " to select the desired item and
press "OK".
Press "
NOTE:
This setting is available only for multi-model, and it needs to take a long time to get information
•
from indoor unit. If the setting is not displayed on "3d: Cycle Operation" screen, please press
"
" to return to "Service Setting" screen, wait for a while and go to "3d: Cycle Operation"
screen again.
9.3.6 Reset 3d: Cycle Operation
Step1.
Select "Reset 3d: Cycle Operation" on "3d: Cycle
Operation" screen and press "OK".
Step2.
Select "Yes" and press "OK" to reset all settings of
menu 3d. After settings are initialized, it turns to
home screen.
70
" to return to Step1.
3d: Cycle Operation
E0: Defrost mode Selection
E1: Thermistor Calibration for Cooling
E2: Thermistor Calibration for Heating
E3: Fan Speed at Cooling Thermo-OFF
E4: Fan Speed at Heating Thermo-OFF
Select
OK
E4: Fan Speed at Heating Thermo-OFF
01: Pattern 1
02: Pattern 2
03: Pattern 3
OK
Select
3d: Cycle Operation
Reset 3d: Cycle Operation
OK
Select
3d: Cycle Operation
Reset 3d: Cycle Operation
Reset all settings of menu 3d?
Yes
Cancel
OK
Select
A16382H32B
(Mon) 16:30
Back
Back
(Mon) 16:30
Back
(Mon) 16:30
Back
Publicité
