Equipotential Bonding; Soldering Instructions; Safety; Accessories - Weller WSF 80 D8 Manuel D'utilisation

3. Equipotential bonding

Four different versions can be obtained by different wiring of the 3.5mm jack bushing (16).
Hart grounded: No plug (state upon delivery)
Equipot. bonding
(impedance: 0 ohms): With plug, equalizing conductor on central contact
Floating: With plug
Soft grounded: With plug and soldered resistor.
Grounding via the selected resistance.

4. Soldering instructions

For initial heating coat the soldering tip (tip can be coated selectively) with solder. This removes
oxide deposits and impurities from the soldering tip that occur during storage. During soldering
breaks and before storing the soldering iron, always ensure that the soldering tip is well
coated with solder. When using very low activated flux agents (no clean), the use of "Tip
Activator" is recommended to maintain the coating.
Dirt, foreign material or damage may not affect the transition between the heating element/
sensor and the soldering tip. This will compromise the precision of the temperature control.
Important: always ensure the soldering tip fits properly.
Keep the heat-conducting surfaces of the heating element and soldering tip clean.
The hot soldering tip may not come in contact with the cleaning sponge or plastic surfaces.
These soldering units have been adjusted for use with a medium-sized soldering nozzle or
jet. Deviations can occur as a result of changing the tip or using other tip shapes.

5. Safety

The manufacturer will not assume liability for uses that deviate from these operating
instructions or for unauthorized modifications.
WSF80D58 34
PK Elektronik Vertriebs GmbH, E-Mail: info@pkelektronik.com, Internet: www.pkelektronik.com
These operating instructions and warnings must be read carefully and kept in an easily
visible location in the vicinity of the soldering unit. Noncompliance with the warnings can
result in accidents, injury or health problems.
The WELLER soldering station WSF 80 D5 / D8 complies with the EC Declaration of Conformity
according to the fundamental safety requirements specified in Directives 89/336/EWG and
73/23/EWG.

6. Accessories

005 13 120 99 Pedal switch
005 13 031 99 Tip Aktivator
Soldering tips:
005 44 403 99 LT A 1.6 mm
005 44 405 99 LT B 2.4 mm
005 44 407 99 LT C 3.2 mm
005 44 443 99 LT ALX 1.6 mm
005 44 442 99 LT BX 2.4 mm
005 44 412 99 LT H 0.8 mm
005 44 420 99 LT HX 0.8 mm
005 44 408 99 LT F 1.2 mm
005 44 444 99 LT BB 2.4 mm
005 44 445 99 LT CC 3.2 mm

7. Scope of supply

Soldering station WSF 80 D5 / D8
Control unit
Feed unit
WSF P soldering iron
Small tool
Soldering iron storage
Power cord
Operating instructions
04.04.2002, 9:26 Uhr
chisel
chisel
chisel
bent
bent
chisel
bent
round, slanted
round, slanted
round, slanted
34