Caution; Putting Into Operation; Equipotential Bonding; Accessories - Weller WSP 150 Mode D'emploi

English
Always place the soldering tool in the
safety rest while not in use.
Thank you for placing your trust in our company by purcha-
sing the Weller soldering iron WSP 150. Production was
based on stringent quality requirements which guarantee the
perfect operation of the device.

1. Caution!

Please read these Operating Instructions and the attached
Safety Information carefully prior to initial operation. Failure
to observe the safety regulations results in a risk to life and
limb.
The manufacturer shall not be liable for damage resulting
from misuse of the machine or unauthorised alterations.
Safety Informations
 Always place the soldering iron in the original holder.
 Remove all inflammable objects from the proximity of the
hot soldering tool.
 Use suitable protective clothing. Risk of burns from liquid
solder.
 Never leave the hot soldering iron unsupervised.
 Never work on voltage-carrying parts.
2. Description
The WSP 150 soldering iron was specially developed for
soldering tasks with extremely high heat requirements. The
150 W heater power combined with the optimal transfer of
heat to the soldering iron bit guarantee the high performan-
ce capability of the soldering iron. Using an integrated equi-
potential bonding wire, it is possible to equipotentially bond
the soldering iron bit as required. The anti-static design of
the handle and cable comply with the requirements for
electrostatic sensitive device safety.

3. Putting into operation

Place the soldering iron in the stand. Remove all flammable
substances from the area around the soldering iron. Plug the
connector (1) into the supply unit and lock. Set the required
temperature on the supply unit. At the end of the necessary
warm-up time, tin the soldering iron bit with some solder.
Technical Data
Supply Voltage:
Power Rating:
Warm Up Time:
Max. Temp.:
5
24 V
150 W
approx. 45 sec. (50ºC - 350ºC)
550ºC

4. Equipotential bonding

If required, the soldering iron bit can be equipotentially bon-
ded via the supply unit used. The possible ways of connec-
ting the equipotential bonding wire are described in the ope-
rating instructions for the supply unit.
5. Instructions for use
Bit Changing
- Hold the soldering iron with the bit slightly downwards.
- Undo the knurled bit retaining nut (2).
- The soldering iron bit is now loose in the knurled nut.
Caution: The soldering tip and the knurled nut are hot.
Always place the soldering iron in the stand when not in use.
Anti-static plastics are treated with conductive material to
prevent static charging. This results in a reduction in the
insulating properties of the plastic.
The operating instructions for the supply unit used are also
applicable in addition to these operating instructions.

6. Accessories

Soldering bits figure LHT-Tips see page 24.
Subject to technical change without notice!
See the updated operating instructions at
www.weller-tools.com.