Using The Device - Tecno-gaz Orma Mode D'emploi

USING THE DEVICE
The Orma machine shall be used in a clean environment without much high‐
conductivity fiber. The ambient temperature is 5°C‐40°C, and the humidity is
not more than 87%. Film used in Orma machine is made of PVC with certain
static electricity. If it is used in the location with the requirement of static
electricity, the application scope must be measured.
In order to ensure the safe usage, please strictly follow the following points:
 Before using Orma , please read this instruction carefully and follow the
operating procedure.
 Before power on, please make sure the input voltage meet the 220v‐
240v.
 In order to avoid chine failure and safety problem, it is prohibited to place
the machine in the open or flush the machine with water for cleaning.
 It is prohibited to cover bare foot with film in the machine.
 It is prohibited to put any foreign matter into the machine.
 The attention of anti‐skid shall be paid, the shoes covered by films are
prohibited to step on a place with water or watered blanket
 During maintenance on the machine, it's necessary to disconnect the
power
 Children are prohibited to use or play the machine.
The power supply must have reliably earthed, or it may cause serious
personal safety or equipment damage problem.
The shoe cover could be used by visitors or only in case of by hospital
operators.
The shoe cover, mustn't be used in environment or activity where there
are electrostatic charge as the same shoes that generate lead to
dangerous situations for users.
Follow instructions step by step for a correctly usage:

Connect to the power: insert both ends of wire into the indoors socket
and the machine socket repectively.

Press to open the machine.

Open the top cover on the machine, and clean up the head of coiled film
to remove burrs and other impurities affecting the installing quality to
ensure the smooth coil.
5
ENGLISH