Rational iCombi Pro Manuel D'installation page 7

4 | Preparations
4 Preparations
Setting up the bottom unit
In order to set up the bottom unit for the
Combi-Duo setup, mount the unit on a
stand with feet, guide rollers or on a level-
ing kit.
Note that the distance X from the exhaust
box of the Combi-Duo unit is at least
50 mm [2 inch] to the wall.
X
For setting up the unit on the stand, follow
the description in the installation manual
for the unit.
Bottom unit alignment
Align the stand: Set up the unit and
n
check the alignment with a spirit level
in the cooking cabinet. If necessary,
align the guide rollers or feet evenly so
that the unit is stable.
Aligning the leveling kit: Set up the
n
leveling kit and check the alignment
with a spirit level before positioning
the bottom unit on the leveling kit.
80.51.377_iCombiPro-iCombiClassic_CD-G_IM_US-nord
5 Installation
Setting up the Combi-Duo and the top
unit
NOTE
Mounting and fixing the top unit on
the top base plate
The top unit is only fixed in place with
three screws on the top base plate. The
forth fixing is difficult to access due to
the exhaust gas pipe cover and is not
essential.
a
The bottom unit is set up on a stand
with feet or guide rollers or a leveling
kit.
a
The top of the bottom unit is clean and
free from grease.
1. Loosen the 3 screws from the cover of
the bottom unit [
2. Place the Combi-Duo base plate on
the bottom unit. Align the base plate
so that the closed, right side panel of
the plate joins flush with the right unit
wall.
3. Fix the Combi-Duo base plate with
3 screws [ Figure
4. Mount the feet on the base plate with
cap nuts [ Figure
5. Place the cover for the exhaust gas
pipes on the bottom unit
[ Figure 05].
6. Mount the holder on the bottom of the
top base plate [
7. Fix the top base plate on the feet
[ Figure 07].
8. Remove the rubber seal around the
unit base edge of the top unit
[ Figure 08].
US-English
Figure 02].
03].
04].
Figure 06].
7 / 28