Beurer BM 28 Mode D'emploi page 29

urement, this indicates that an irregularity has been detected in
your pulse.
Repeat the measurement if
When assessing your blood pressure, only use the results that
have been recorded without any irregularities in your pulse.
Consult your doctor if is displayed frequently. Only they can
determine, through an examination, whether there is an abnor-
mality.
Risk indicator
Measured blood pres-
sure value range
Classification
Systolic (in Diastolic
mmHg) (in mmHg)
Stage 3 high blood
≥ 180 ≥ 110
pressure (severe)
Stage 2 high blood
160 – 179 100 – 109
pressure (moderate)
Stage 1 high blood
140 – 159 90 – 99
pressure (mild)
130 – 139 85 – 89 High normal
120 – 129 80 – 84 Normal
< 120 < 80 Optimal
< 90 < 60 Low blood pressure
Source:
1
Source:
2
The risk indicator / indicates which category the recorded
6 21
blood pressure values fall into. If the measured values are in two
di erent categories (e.g. systolic pressure in the "high normal"
range and diastolic pressure in the "normal" range), the risk in-
is displayed.
Risk
indicator
colour
Red
1
Orange
1
Yellow
1
Green
1
Green
1
Green
1
Orange
2
dicator always indicates the higher range – "high normal" in the
example described.
Note that these default values are for general guidance
only, as individual blood pressures may vary.
Please note that self-measurement at home usually results in val-
ues lower than those recorded at a doctor's surgery. Consult your
doctor at regular intervals. Only they are able to give you personal
target values for controlled blood pressure, particularly if you are
receiving medical therapy.
Low blood pressure
 WARNING
Low blood pressure (hypotension) can be a health hazard and
cause dizziness or fainting. Blood pressure is considered low if
systolic and diastolic pressure are below 90/60 mmHg (source:
National Health Service, 2023).
Seek medical attention if you suddenly su er from low blood
pressure.
Resting indicator (using HSD diagnostics)
One of the most common errors made when taking a blood pres-
sure measurement is not ensuring that the user's circulatory sys-
tem is su ciently at rest when taking the measurement. In this
case, the measured systolic and diastolic blood pressure values
do not represent the blood pressure at rest. However, it is this
blood pressure at rest that should be used to assess the meas-
ured values.
This blood pressure monitor uses integrated haemodynamic sta-
bility diagnostics (HSD) to measure the user's haemodynamic
stability when taking the blood pressure measurement. This ena-
bles it to indicate whether the blood pressure was taken when the
user's circulatory system was su ciently at rest.
29