Beurer BM 28 Mode D'emploi page 26

6. USAGE
6.1 Initial use
Inserting the batteries
• Remove the battery compartment cover on the back of the
device .
A
• Insert four 1.5-V AA (alkaline type LR6) batteries. Insert the
batteries, making sure the polarity is correct according to the
label .
A
• Close the battery compartment cover.
If the symbol is displayed and does not disappear, meas-
urement is no longer possible. Replace all the batteries. Once the
batteries have been removed from the device, the date and time
must be set again. Any saved measured values are retained.
Operation with the mains part
You can also operate this device with a mains part (not included in
delivery). However, before connecting the device with the mains
part, please ensure that you have removed the batteries from the
device. During mains operation, there must not be any batteries in
the battery compartment, as this could damage the device.
• To avoid any potential damage, the device may only be oper-
ated with a mains part that meets the specifications described
in the chapter "Technical specifications".
• Furthermore, the mains part must only be connected to the
mains voltage that is specified on the type plate.
• Insert the mains part into the connection provided for this pur-
pose on the right-hand side of the blood pressure monitor.
• Then insert the mains plug of the mains part into the mains
socket.
• After using the blood pressure monitor, unplug the mains part
from the mains socket first and then disconnect it from the
blood pressure monitor. As soon as you unplug the mains
part, the blood pressure monitor loses the date and time set-
ting but the saved measured values are retained.
Adjusting the settings
Make sure that the device's settings have been set correctly so
you can make full use of all its functions. Otherwise you will not
be able to save your measured values with the date and time and
access them later.
There are two di erent ways to access the settings menu:
• Before initial use and after each time you replace the battery:
When inserting batteries into the device, you will be taken to
the relevant menu automatically.
• If the batteries have already been inserted:
With the device switched o , press and hold the SET but-
ton for approx. 5 seconds.
To set the date and time, proceed as follows:
• Select 12h or 24h mode using the function buttons -/+. Press
SET to confirm. The year display will start to flash. Set the year
with the function buttons -/+ and confirm with SET.
• Set the month, day, hour and minute and confirm each with
the SET button.
• The blood pressure monitor switches itself o automatically.
Alarm
Set alarm:
You can set 2 di erent alarm times to remind yourself to take the
measurement. To set the alarm, proceed as follows:
• Press and hold the function buttons - and + simultaneously
for 5 seconds.
26